Frequently Asked Questions About Kenworth W900A Hood Emblems & Bezels

Will these emblems and bezels fit my specific year Kenworth W900A?

Most aftermarket hood emblems and bezels are designed to fit Kenworth W900A models from 1961 through 1985. However, there were minor variations in mounting hole patterns between early models (1961-1972) and later models (1973-1985). Always verify the mounting hole spacing on your hood before ordering. If you're unsure, measure the distance between your existing mounting holes or contact us with your truck's VIN for verification.

What's the difference between chrome plastic and die-cast metal emblems?

Chrome-plated plastic emblems are lightweight and budget-friendly but may fade or yellow after 2-3 years of sun exposure. Die-cast metal emblems with triple chrome plating cost more upfront but typically last 10+ years without significant deterioration. Metal emblems also have more detailed relief and a heavier, premium feel. For trucks in harsh climates or those frequently washed, metal emblems are worth the investment.

Do I need to drill new holes or modify my hood for installation?

Most replacement emblems use existing factory mounting holes, requiring no drilling. Standard Kenworth hood emblems typically use 2-4 mounting studs with nuts on the backside. Some aftermarket bezels may require slight enlargement of existing holes if upgrading from flat emblems to raised bezels. Always test-fit before final installation and use a step drill bit if hole adjustment is needed.

What tools and hardware do I need for proper installation?

You'll need a 7/16" or 1/2" socket wrench for most emblem nuts, masking tape to protect the hood finish, and thread-locking compound to prevent loosening. Many emblems come with new stainless steel mounting hardware, but verify this before ordering. For bezels, you may also need weatherstrip adhesive or double-sided automotive tape for additional security. Allow 30-45 minutes for careful installation.

How do I remove old emblems without damaging my hood paint?

Heat the emblem gently with a heat gun or hair dryer to soften any adhesive, then carefully work dental floss or fishing line behind the emblem to cut through adhesive. For stud-mounted emblems, spray penetrating oil on the back nuts and let sit for 10 minutes before removal. Clean residual adhesive with adhesive remover and clay bar. Never pry directly against the hood surface, as this will chip paint.