Front Axle Air Ride Kit Fits Peterbilt 567

* High Quality Front Axle Air Ride Kit
* Kit Includes:
  - (2) Angle Bracket
  - (2) Top Plate
  - (2) Double Convolute Air Spring
  - (2) Bottom Mounting Plate 4 Inch
  - (6) Hex Head Cap Screw 1/2 Inch X 2 Inch Long
  - (4) Hex Head Cap Screw 1/2 Inch X 1 Inch Long
  - (16) Washers 1/2 Inch
  - (6) Lock Nut 1/2 Inch UNC
  - (4) Allen Head Screw 3/8 Inch X 1 Inch Long
  - (4) Washer 3/8 Inch
  - (4) Hex Head Cap Screw 3/8 Inch X 1 Inch Long
* Sold As A Kit
* Warranty On Axle Air Ride Kit Against Defects In Workmanship & Material From Date Of Purchase

*** High Quality Aftermarket Replacement Part (Not OEM)***
** Warning: Do not inflate assembly when it is unrestricted. Assembly must be restricted by suspension or other adequate structure. Do not inflate beyond 100 PSI. Improper use or over-inflation may cause assembly to burst, causing property damage and/or severe personal injury. With a load on your truck and the air springs inflated, you must have at least one inch clearance all around the air bellows. FOR BEST RIDE use only enough air pressure in the air springs to level the vehicle when viewed from the side. Inflate the air springs to maintain this height under any conditions of load. Too much air pressure in the air springs will result in a stiffer ride. Too little air pressure will allow the vehicle to bottom out and not provide the improvement in handling that is possible. To prevent possible damage, always maintain a minimum of 2 PSI in the Load-Share bellows.

** This Item Is Special Order. This Item Will Not Be Able To Be Canceled And Is Non-Returnable.