Front Axle Air Ride Kit For Round U-Bolts

Level your truck and achieve a smoother, more level ride with this front axle LoadShare air ride kit. It provides a more comfortable ride and reduces strain on your trucks suspension. It increases stability and improves handling and steering. It can be adjusted to varying load requirement or road conditions with convenient in cab controls.

* High Quality Front Axle Air Ride Kit
* Kit Includes
  - Air Control Panel Kit, Part # 29-050920
  - Shock Mounting Kit, Part # 29-050902
  - (2) Angle Brackets
  - (2) Top Plates
  - (2) Double Convolute Air Springs
  - (2) Bottom Mounting Plate 4 Inch
  - (6) Hex Head Cap Screws - 1/2 Inch UNC By 2 Inch Length
  - (4) Hex Head Cap Screws - 1/2 Inch UNC By 1 Inch Length
  - (16) 1/2 Inch Washers
  - (6) Locknuts - 1/2 Inch UNC
  - (4) Allen Head Screws 3/8 Inch UNC By 1 Inch Length
  - (4) 3/8 Inch Washers
  - (4) Hex Head Cap Screws 3/8 Inch UNC By 1 Inch Length
* Standard U-Bolt Spacing
* 4 Inch Leafspring Width
* 7-5/8 Inch Collapsed Kit Height
* Fits Models with Round U-Bolts Only
* Sold As Kit
* Warranty On Front Axle Air Ride Kits Against Defects In Workmanship & Material From Date Of Purchase

***High Quality Aftermarket Replacement Part (Not OEM)***

** Warning: Do not inflate assembly when it is unrestricted. Assembly must be restricted by suspension or other adequate structure. Do not inflate beyond 100 PSI. Improper use or over-inflation may cause assembly to burst, causing property damage and/or severe personal injury.
With a load on your truck and the air springs inflated, you must have at least one inch clearance all around the air bellows. FOR BEST RIDE use only enough air pressure in the air springs to level the vehicle when viewed from the side. Inflate the air springs to maintain this height under any conditions of load. Too much air pressure in the air springs will result in a stiffer ride. Too little air pressure will allow the vehicle to bottom out and not provide the improvement in handling that is possible. To prevent possible damage, always maintain a minimum of 2 PSI in the Load-Share bellows.