Peterbilt 567/579 Shift Plates

Frequently Asked Questions About Peterbilt 567/579 Shift Plates

What is a shift plate and what does it do?

A shift plate is a decorative and protective cover that fits around the gear shifter base on the floor or console of your Peterbilt 567 or 579. It conceals the shifter boot, wiring, and mounting hardware while adding a finished, upgraded look to the cab interior.

Will a shift plate fit my specific Peterbilt model and transmission type?

Shift plates are designed to match the floor layout and shifter style of either the 567 or 579, so it is important to confirm your truck model and whether you have an automatic, manual, or automated manual transmission before ordering, since the shifter base and boot cutout can differ between these setups.

What materials and finishes are these shift plates available in?

Shift plates in this category are commonly offered in finishes such as stainless steel, chrome, and painted or textured options. Stainless and chrome plates tend to hold up well against scuffing and wear from daily use, while painted finishes can offer a closer factory match if that is your preference.

How difficult is it to install a shift plate?

Most shift plates are designed as a direct bolt-on or snap-fit replacement for the factory piece, using the existing mounting points around the shifter base. Basic hand tools are typically all that is needed, and no cutting or drilling is usually required, but always check the included instructions since fitment steps can vary by design.

Will adding a shift plate affect the operation of my shifter or interfere with other cab components?

A properly fitted shift plate should not interfere with shifter movement, cables, or wiring underneath, since it is designed to sit around the existing components rather than replace them. If you notice any binding or rubbing during installation, double check that you have the correct plate for your cab and shifter configuration before proceeding.